Pair of performance Dyna 12 volt 5 ohm single lead ignition coils with angled HT lead socket. These are a cooler running coil that offer improved starting and performance

Dyna Performance Replacment Coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions. These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount.
Individual coils available by special order, call us for details. See ELA00001 for crimp on HT lead connector

 This part is due back in stock soon, call 01484 841395 to reserve yours

1471650

Pair of high performance Dyna 12 volt 5 ohm dual lead ignition coils with angled HT lead socket. These are a performance coil which offer improved starting and performance for twin plugged models

Dyna Performance Replacment twin plug coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions. These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount. Guzziology recommends using electronic ignition with these coils as points may not be up to triggering these coils. See ELA00001 for crimp on HT lead connector.
Individual coils available by special order, call us for details

 This part is available by special order, request a quote

1471650

Pair of low and high chrome Voxbell Fiamm type snail horns. Very loud and Italian!

Chromed plastic grill and cover, also known as Guzzi ref. 28743761. Sold with brackets, can be fitted to most Guzzis

 This part is available by special order, request a quote

28743760-z 28743760 GU28743760 28 74 37 60
 2874 3760 2874.3760 28.74.37.60

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Complete Newtronic electronic ignition kit containing ignition pickup (distributor mounted) and ignition box. Retains original mechanical advance / retard mechanism.

Kit consists of sensor plate and pickups, magnet, ignition box, clip, screws and instructions. Suitable for all models originally fitted with points which have a mechanical advance / retard . Can also be fitted to Strada 1000, Spada 3, Cali 3 etc... if the distributor is swapped for a points type part with advance / retard mechanism. Coils should have 4 Ohms resistance on the low tension circuit, OE coils will work OK but you may see improved results with high performance Dyna coil ELA14101

Developed from the original Piranha system, Newtronic ignitions are contact breaker replacement ignition systems covering a range of Japanese and European motorcycles from the late 1950's onwards. Using contactless, maintenance free, infra red triggering the Newtronic ignition has gained a reputation for ease of installation and effectiveness from satisfied motorcyclists around the World. The switching units include an integrated timing LED for each channel, making it quick and easy to accurately time each cylinder independently (an essential step in gaining the best performance from your engine.). The system typically consists of three main components:

1. An ADAPTOR plate which mounts the lamps supplying the beam of infra-red light. This is broken by the ROTOR as it rotates on the engine cam or crankshaft. When a beam of light is re-made as the rotor blade clears the beam the switching unit is instructed to fire the coil (please note some systems will have separate mounting plates for each lamp and will not be assembled on a single plate as shown.) In many kits these are supplied as 1 lamp per cylinder. Other kits use a wasted spark system with 1 lamp firing 2 cylinders. The adapter kit also includes the parts needed to fit the lamps around the motorcycle cam or crankshaft - usually supplied as a base plate and /or segment plates with pre-mounted lamps.
2. A ROTOR which fits on the bike cam or crankshaft and makes and breaks the lamps infrared beam when the coil is to be fired. The rotor may be made of metal or a heat and solvent resistant plastic.
3. A SWITCHING UNIT which collects coil firing instructions from the rotor traversing through the lamps and fires the coil. The switching units are supplied positive or negative earth depending on the bike configuration and have a separate switching channel for each lamp in the Adaptation Kit. 12V and 6V versions are also available especially for earlier bikes. The switching unit has an integral timing light for each coil and is fully compatible with existing systems to the older design. It is also a direct replacement for Piranha switching units.
4. An INSTALLATION WIRING LOOM is supplied with each kit, tailored to the original bike loom dimensions, connectors and wire colours for a quick, easy and professional looking installation.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Neutral indicator switch

 Availability varies on this part, check availability

 12207200 GU12207200 12 20 72 00
 1220 7200 1220.7200 12.20.72.00

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 This part is due back in stock soon, call 01484 841395 to reserve yours

Set of leads for batter charging. Ring terminals for battery, 2 pin connector for charger to plug into. Often required if you charge more than one bike using your Motobatt Smart Charger

 2 in stock

Motobatt quadflex 30Ah battery. Quadflex technology means you have two positive and two negative threaded terminals allowing maximum flexibility when installing. This powerful battery produces a massive 390 cranking amps, and is rated at 32 ah.

These sealed absorbed glass matt batteries have been used in military and off road applications for many years.
They offer increased lifespan, higher vibration resistance and electrical performance. This battery is also leak, vibration and spill proof if installed correctly.
Supplied fully charged and ready to fit.

NB This battery must not be trickle charged or charged using a traditional manual charger, AGM batteries require a smart charger - we recommend ACA96000
For more information on charging AGM batteries see these FAQ's.

This is a better value replacement for the Odyssey PC925 battery. Replaces Guzzi refs. 14704550, 18704550, 28704550, 28704545, 28704551, 28704552, 14704551, 14704500 and 14704505

One year warranty on all our Motobatt batteries.

Slightly taller than original loop frame battery so you may need to make some modification to retaining bracket

Please note this part CANNOT be posted outside of the UK mainland area

 1 in stock

03704540-z 03704540 GU03704540 03 70 45 40
 0370 4540 0370.4540 03.70.45.40

Male molex connector, OE spec for female block connectors

Block connectors available separately, use these to replace wiring in your loom block connectors

 More than 5 in stock